38 Chapter 4: Accessories
Accessories
Auxiliary Power Cable
The auxiliary power cable is used with the power supply to charge the system battery when the
system is not in use and a docking station or stand is not available.
To connect the auxiliary power cable:
1 Lay the system on a flat surface with the display side up.
2 Insert the cable (screws facing up) into the connector on the bottom on the system.
3 Connect the power supply to the auxiliary power cable and connect the power supply to AC
power cord.
Note: To check the battery charge, disconnect the cable, power on the system and check the battery
charge icon.
To disconnect the auxiliary power cable:
1 Squeeze the sides of the cable to release it from the system.
2 Pull the connector straight out.
Caution: To avoid damaging the system connector or the auxiliary power cable, always
unplug the cable before scanning.
Caution: Permanent damage to the iLook system, power supply, or auxiliary power cable
could result if the connector is inserted incorrectly.
To Next Page
Loading...
