Chapter 4: Accessories 37
Accessories
Battery
To charge the system battery:
1 Insert the battery into the battery compartment of the system. See “To install the battery:” on
page 4.
2 Insert the system into the docking station or stand, connecting the I/O connector on the bottom
of the system to the I/O connector on the docking station or stand.
The system beeps when connected properly.
If you are using the docking station, the indicator lights on left side of docking station show the
charging status of the system battery. Amber indicates the battery is charging and green
indicates a fully charged battery. See Figure 1 on page 33.
Note: If the indicator lights do not come on, push down gently until it is properly seated and verify the
power is properly connected.
To charge the extra battery using the docking station:
Insert a battery into the battery charger on the back right side of the docking station. See Figure 1 on
page 33.
The indicator lights on the right side of the docking station show the charging status of the extra
battery. Amber indicates the extra battery is charging and green indicates a fully charged extra
battery.
To Next Page
Loading...
