Sony a200 - Page 15

=
=
-
:T
CD
n
I»
3
CD
-
I»
•
• We recommend charging the battery pack in an ambient temperature of
between 10 to 30°C (50 to 86°P). You may not be able to efficiently
charge the battery pack outside
of this temperature range.
Notes
• Connect the battery charger to an easily accessible wall outlet (wall socket) close by.
• Even
if the CHARGE lamp is not lit, the battery charger is not disconnected from the "'tJ
-
AC power source (mains) as long as it is connected to the wall outlet (wall socket). If CD
"'CS
some trouble occurs while using the battery charger, immediately shut off the power ~
--
by disconnecting the plug from the wall outlet (wall socket).
• When charging is finished, disconnect the power cord (mains lead) from the wall
outlet (wall socket), and remove the battery pack from the battery charger.
If you
leave the charged battery pack on the charger, battery life may be decreased.
• Do not charge any battery pack other than the "InfoLITHIUM" M series battery
pack in the battery charger (supplied) with your camera. Batteries other than the
specified kind may leak, overheat, or explode
if you attempt to charge them, posing a
risk
of injury from electrocution and bums.
• When the CHARGE lamp flashes, this may indicate a battery error or that a battery
pack other than the specified type have been installed. Check that the battery pack is
the specified type.
If the battery pack is the specified type, remove the battery pack,
replace it with new one
or another one and check if the battery charger operates
correctly.
If the battery charger operates correctly, a battery error may have
occurred.
• If the battery charger is dirty, charging may not be performed successfully. Clean the
battery charger with dry cloth, etc.
To use your camera abroad - Power sources
You can use your camera and the battery charger and the AC-VQ900AM
AC Adaptor/charger (not supplied) in any country or region where the
power supply is within 100 V to 240 V AC, 50/60 Hz. Use a commercially
available AC plug adaptor [a],
if necessary, depending on the design of the
wall outlet (wall socket) [b].
BC-VM10 rc-=.~."
[a] [b]
Note
• Do not use an electronic transformer (travel converter), as this may cause a
malfunction.
15
=
=
-
:T
CD
n
I»
3
CD
-
I»
•
• We recommend charging the battery pack in an ambient temperature of
between 10 to 30°C (50 to 86°P). You may not be able to efficiently
charge the battery pack outside
of this temperature range.
Notes
• Connect the battery charger to an easily accessible wall outlet (wall socket) close by.
• Even
if the CHARGE lamp is not lit, the battery charger is not disconnected from the "'tJ
-
AC power source (mains) as long as it is connected to the wall outlet (wall socket). If CD
"'CS
some trouble occurs while using the battery charger, immediately shut off the power ~
--
by disconnecting the plug from the wall outlet (wall socket).
• When charging is finished, disconnect the power cord (mains lead) from the wall
outlet (wall socket), and remove the battery pack from the battery charger.
If you
leave the charged battery pack on the charger, battery life may be decreased.
• Do not charge any battery pack other than the "InfoLITHIUM" M series battery
pack in the battery charger (supplied) with your camera. Batteries other than the
specified kind may leak, overheat, or explode
if you attempt to charge them, posing a
risk
of injury from electrocution and bums.
• When the CHARGE lamp flashes, this may indicate a battery error or that a battery
pack other than the specified type have been installed. Check that the battery pack is
the specified type.
If the battery pack is the specified type, remove the battery pack,
replace it with new one
or another one and check if the battery charger operates
correctly.
If the battery charger operates correctly, a battery error may have
occurred.
• If the battery charger is dirty, charging may not be performed successfully. Clean the
battery charger with dry cloth, etc.
To use your camera abroad - Power sources
You can use your camera and the battery charger and the AC-VQ900AM
AC Adaptor/charger (not supplied) in any country or region where the
power supply is within 100 V to 240 V AC, 50/60 Hz. Use a commercially
available AC plug adaptor [a],
if necessary, depending on the design of the
wall outlet (wall socket) [b].
BC-VM10 rc-=.~."
[a] [b]
Note
• Do not use an electronic transformer (travel converter), as this may cause a
malfunction.
15