9
!¡ Function buttons
Use these buttons to control the operation of the
monitor.
Each of these buttons has a Shift On function,
indicated below the button, as well as a Shift Off
function, indicated above the button. Press the SHIFT
button 0 to select the desired function.
Each time you press one of these buttons, its LED
lights or goes out and the function of the button
selected with the SHIFT button 0 is turned on or off.
The LED color change whether you select Shift Off
functions or Shift On functions.
For Shift Off functions: Green LED
For Shift On functions: Orange LED
Shift Off functions (green LED)
(underscan): Turn the button on for underscanning. The display size is
reduced by approximately 3%, so that the four corners of the raster are
visible.
(horizontal delay): Turn the button on to observe the horizontal sync
near the left quarter of the screen.
• Picture brightness is adjusted automatically for easy observation.
• Press the button together with the button to observe a pulse
cross.
(vertical delay): Turn the button on to observe the vertical sync signal.
The picture is shifted vertically and the vertical signal is displayed near
the center of the screen.
• Picture brightness is adjusted automatically for easy observation.
• Press the button together with the button to observe a pulse
cross.
MONO (monochrome): Turn the button on to display color pictures in
monochrome. When the button is off, the monitor switches automatically
between color and monochrome mode, depending on the presence or
absence of color burst signal.
APT (aperture): Turn the button on to perform aperture correction of
frequency characteristics. Use the monitor menu to select the amount of
correction.
This function is available when an optional decoder adaptor such as a
BKM-24N is installed.
COMB (comb filter): Turn the comb filter on and off.
This function is available when an optional decoder adaptor such as a
BKM-24N is installed.
F1 and F2: These buttons are reserved for future use.
ADDRESS: Turn the button on to display the ADDRESS menu on the
monitor screen. You can use the ADDRESS menu to set operating
parameters for several monitors.
For more information about the ADDRESS menu, see “Selecting the Monitor
to Control —ADDRESS Menu” on page 59.
MONO
APT
COMB
F1
F2
ADDRESS
16 : 9
SYNC
BLUE
ONLY
R
G
B
F3
F4
SAFE
AREA
To Next Page
Loading...
