25
The color temperature is adjusted with the COLOR
TEMP ADJ menu. The color temperature can be set
either commonly to all channels or individually for
each channel.
The adjusted value can then be used as an original
value.
Color temperature adjustment can be made in the
following three ways:
(1) Knob adjustment
Adjust the color temperature with the bias and gain
knobs.
(2) Automatic adjustment using a probe
You can use the following probes for automatic
adjustment of color temperature. Except for the Sony
BKM-14L, a cable is required to connect the probe to
the monitor.
Adjusting the Color Temperature — COLOR TEMP
ADJ Menu
For more information about the required cables, see page
29.
(3) Copying other data
Copying data from other channels, common data, other
BVM-series monitors that have been connected via the
serial remote connector, or from data stored in monitor
memory cards
Manufacturer Probe Model Name
SONY BKM-14L (no cable required)
MINOLTA CA-100
GRASEBY SLS 9400
PHILIPS PM 5639
THOMA TF6
Structure and Usage of the COLOR TEMP ADJ Menu
This section explains the setting lists displayed in the
menu. .
How to read the setting lists
•For purposes of explanation, each setting list is
preceded by a 3-digit number. These numbers are not
displayed on the screen.
•Setting lists are indented to indicate their position in
the tree structure of the menu. (When list YYY is
found under list XXX, it is indented to the right of
list XXX.)
•The arrow mark (÷) refers you to another setting
list that appears after you make the setting, or to an
operation that is carried out as a result of the setting.
When there is no arrow mark, you can make the
setting using a single list.
Select COLOR TEMP ADJ from the main menu list.
CONTROL PRESET ADJ...
COLOR TEMP ADJ... ÷ 200
SET UP...
MEMORY CARD...
COPY...
STATUS...
MAINTENANCE...
KEY PROTECT OFF
Menu list
To Next Page
Loading...
