56
When multiple monitors are connected via their serial
remote ports, data can be shared between the monitors
by data copy. The data copy from one monitor to
another is accomplished with the COPY menu.
Structure and Usage of the COPY Menu
This section explains the setting lists displayed in the
menu.
How to read the setting lists
•For purposes of explanation, each setting list is
preceded by a 3-digit number. These numbers are not
displayed on the screen.
•Setting lists are indented to indicate their position in
the tree structure of the menu. (When list YYY is
found under list XXX, it is indented to the right of
list XXX.)
•The arrow mark (÷) refers you to another setting
list that appears after you make the setting, or to an
operation that is carried out as a result of the setting.
When there is no arrow mark, you can make the
setting using a single list.
Select COPY from the menu list.
CONTROL PRESET ADJ...
COLOR TEMP ADJ...
SET UP...
MEMORY CARD...
COPY... ÷ 850
STATUS...
MAINTENANCE...
KEY PROTECT OFF
Menu list
850 COPY menu: Select the copy source monitor.
MONITOR ADDRESS: Enter the address number. ÷ 851
851 COPY: Select the data to be copied. ÷ Copy is carried out.
ALL: Copy data for all menu settings.
CONTROL PRESET: Copy the data for the CONTROL PRESET ADJ menu settings.
COLOR TEMP: Copy the data for the COLOR TEMP menu settings.
SET UP: Copy the data for the SET UP menu settings.
Monitor-to-Monitor Data Copy — COPY Menu
To Next Page
Loading...
