19
Entering Characters
Example: changing the CHANNEL NAME setting in
the INPUT CONFIGURATION menu to CAM2
The PHASE knob or UP and DOWN buttons are used
to enter characters.
1 Move the cursor to the CHANNEL NAME line in
the INPUT CONFIGURATION menu (2/2).
10 CH
INPUT CONFIGURATION ↑
FILTEROFF
CHANNEL NAME... CAM
CONTROLPRESET
COLOR TEMP... STD
HPHASE100
SAD H POSITION 000
COPY...
p
INPUT CONFIGURATION menu (2/2)
2 Press the ENTER button.
The CHANNEL NAME setting list is displayed.
CHANNEL NAME
PROG
EDIT
CAM
VTR
NEW NAME
p
CHANNEL NAME setting list
3 Using the UP or DOWN button, move the cursor to
the NEW NAME line.
CHANNEL NAME
PROG
EDIT
CAM
VTR
NEW NAME
p
4 Press the ENTER button.
The “?” is displayed on the last line of the list (in
yellow).
CHANNEL NAME
PROG
EDIT
CAM
VTR
NEW NAME
?
p
“?” indicates the position where character input is
possible.
5 Press the UP or DOWN buttons, or turn the
PHASE knob, until “C” is displayed.
When the UP button is pressed, the display will
cycle through letters, numbers, and symbols, in the
following order. When the DOWN button is
pressed, the display will cycle in the opposite
order.
A, B, ..., Y, Z, 0, 1, ..., 8, 9, (, ), :, ;, ., –. +, /, &,
CH, (space), ?
Press the ENTER button.
CHANNEL NAME
PROG
EDIT
CAM
VTR
NEW NAME
C?
p
(continued)
]
To Next Page
Loading...
