17
Changing the Settings
The setting procedure differs with different menu
items. There are four different types of settings:
(1) Choosing one of two or more selections on a
current setting list (items without “...” mark)
(2) Choosing one of two or more selections using sub-
setting list (items with “...” mark)
(3) Entering a numerical value
(4) Entering characters
Aborting menu operation
The setting or adjustment being performed is canceled,
and data loading or saving is aborted.
If “NG” or “ERROR” appears during menu
operation
Press the MENU button to continue the operation.
Choosing One of Two or More Selections
about Items without “...” Mark
Example: changing the SYNC MODE setting in the
INPUT CONFIGURATION menu
1 Move the cursor to the SYNC MODE line in the
INPUT CONFIGURATION menu.
APERTURE OFF
APERTURE VALUE 100
10 CH
INPUT CONFIGURATION ↓
FORM AT... NTSC-7 .5
SLOTNO2
INPUTNO1
YCSEP...3LINES COMB
SYNC MODE INT
SCREEN MODE... 4:3-NORM
SAFE AREA OFF
SAFE AREA SCALE... 80%
p
INPUT CONFIGURATION menu
2 Press the ENTER button.
INT is displayed in yellow text.
3 By pressing either the UP or DOWN button, INT
changes to EXT.
APERTURE OFF
APERTURE VALUE 100
10 CH
FORM AT... NTSC-7 .5
SLOTNO2
INPUTNO1
YCSEP...3LINES COMB
SYNC MODE EXT
SCREEN MODE... 4:3-NORM
SAFE AREA OFF
SAFE AREA SCALE... 80%
p
INPUT CONFIGURATION ↓
Each time the UP or DOWN button is pressed, the
value switches between INT and EXT.
4 When EXT is displayed, press the ENTER button.
The SYNC MODE is set to EXT. (EXT is again
displayed in white text.)
Choosing One of Two or More Selections
about Items with “...” Mark
Example: changing the SCREEN MODE setting in the
INPUT CONFIGURATION menu
1 Move the cursor to the SCREEN MODE line in the
INPUT CONFIGURATION menu.
APERTURE OFF
APERTURE VALUE 100
10 CH
INPUT CONFIGURATION ↓
FORM AT... NTSC-7 .5
SLOTNO2
INPUTNO1
YCSEP...3LINES COMB
SYNC MODE INT
SCREEN MODE... 4:3-NORM
SAFE AREA OFF
SAFE AREA SCALE... 80%
p
INPUT CONFIGURATION menu
(continued)