43
Setting the Channel Selection Method and Power-
Up Conditions — SYSTEM CONFIGURATION Menu
The SYSTEM CONFIGURATION menu is used for
the following settings:
(1) Channel number entry method
The two ways in which the ten-key pad can be used to
enter channel numbers are as follows:
(In the explanation below, x and y represent any digit
between 1 and 9.)
DIRECT mode: When selecting a number from 1 to
9, press the x button to display channel x. When
selecting a number from 10 to 99, press the 0, x,
and y buttons to display channel xy (a two-digit
channel number).
10KEY mode: When the x button is pressed followed
by the ENTER button, the monitor displays channel
x. When the x button is pressed, followed by the y
and ENTER buttons, the monitor displays channel
xy (a two-digit channel number). This mode is
selected at the shipping.
When multiple monitors are connected by a serial
remote connection, this setting will be common to all
the monitors. It is not possible to change the setting
for individual monitors.
(2) Power-up condition
This menu sets the condition of the monitor when the
main power switch on the rear panel is switched on.
ON: Standby mode
OFF: Operation mode
(3) Power-up input channel
LAST: Set the channel to the channel that was
selected at the time the power was last turned off.
CH xx: Set the channel to a specific channel number.
(4) Time from power-up until degauss
If several monitors are turned on at the same time and
all start degaussing at the same time, there will be a
very large current draw on the power supply for a few
moments. To prevent this, the delay time between
power-up and degaussing can be set for each monitor
independently.
(5)AFC time constant
(6)Residual subcarrier detection (when using the
BKM-24N/25P)
It is possible to detect residual subcarrier signals from
phase change by setting the adaptor’s residual
subcarrier switch on.
(7)Auto chroma control (ACC) (when using the
BKM-27T)
To Next Page
Loading...
