7
Location and Function of Parts
Front Panel
1 Tally lamp
With factory settings, the Tally lamp lights when pins
No. 3 and No. 8 of the REMOTE 2 connector on the
rear panel are connected. By changing the setting in
the REMOTE menu, different pins on the remote
connector can be used to control the tally lamp.
For information about the REMOTE menu, see “Assigning
the Remote Control Functions —REMOTE Menu” on page
38.
2 POWER switch
Press to power the BVM-14F5U/14F5E/14E5U/14E5E
on or off. If your system includes more than one
monitor, you can use the ADDRESS menu to power a
selected monitor on or off, or to power all monitors on
or off at once.
For more information about the ADDRESS menu, see
“Selecting the Monitor to Control —ADDRESS Menu” on
page 59.
!º SHIFT button
!¡ Function buttons
!™ Monitor memory
card insertion slot
!£ OPTION connector
9 OVER LOAD lamp
1 Tally lamp
2 POWER switch
3 DEGAUSS button
4 Numeric keypad
5 MANUAL adjustment
buttons and knobs
6 Menu operation buttons
7 POWER lamp
8 STANDBY lamp
3 DEGAUSS button
Press to manually degauss the monitor CRT. When
degaussing repeatedly, wait for 5 minutes before
pressing the button again. (The monitor CRT is
degaussed automatically each time the power is turned
on.)
4 Numeric keypad
Use the numeric keypad to enter menu settings and
channel numbers for signals that you want to input to
the monitor.
INPUT
1
2
3
Del
4
5
6
0
7
8
9
Ent
Ent (enter) button: Confirms a
number or character (the same
function with the ENTER button of the
Menu operation buttons 6).
0 to 9 buttons
Del (delete) button: Deletes a
number or character entered .
To Next Page
Loading...
