Sony BVM-14F5U - Basic Menu Operations; Menu Navigation and Exit; ADDRESS Menu Functionality

15
Basic Menu Operations
The various functions and operating conditions of the
BVM-14F5U/14F5E/14E5U/14E5E can be set with
on-screen menus.
Displaying the Menus
Press the MENU button.
The menu list is displayed on the screen.


CONTROL PRESET ADJ...
MENU      
COLOR TEMP ADJ...
SETUP...
MEMORY CARD...
COPY...
STATUS...
MAINTENANCE...
KEY PROTECT  OFF

p
Menu list
Choose the menu for the adjustment or setup you wish
to perform. The adjustments and settings which can be
made with the menus are described below.
CONTROL PRESET ADJ menu: Sets the preset
values for the input signal contrast, brightness,
chroma, and phase.
COLOR TEMP ADJ menu: Sets the color
temperature.
SET UP menus: A menu group for performing
monitor setup, consisting of the following.
INPUT CONFIGURATION menu: Sets the
input channel.
REMOTE menu: Sets the remote control
functionality.
PASSWORD menu: Sets passwords for menus.
SYSTEM CONFIGURATION menu: Sets the
input channel selection method and power-up
conditions.
ON SCREEN SET menu: Sets data about the
screen display.
ALIGNMENT menu: Used to adjust the screen
convergence and geometry.
EXTEND MENU: Used to back up the monitor data
and re-load the factory data from the installed
board.
MEMORY CARD menu: Operates on data in the
memory card.
COPY menu: Copies set-up data from other
connected monitors.
STATUS menu: Displays the information about the
monitor or options installed in the monitor.
MAINTENANCE menu: Menu for maintenance
(typically not used).
KEY PROTECT: When set to ON, function buttons
on the control unit (with the exception of menu
operation buttons) will be disable. When set to
OFF, key protection is removed.
Note
On this monitor, menu settings displayed in blue
cannot be changed.
To Exit the Menus
Press the MENU button repeatedly until the menu
disappears.
ADDRESS Menu
The ADDRESS menu is used to select the monitor or
the monitor group, so that when several monitors are
connected together via serial remort ports, the control
panel can select which monitor to control.
To display or exit the ADDRESS menu, press the
ADDRESS button. The method of choosing menu
items and changing settings is the same as with the
other menus.
For information about the ADDRESS menu, see “Selecting
the Monitor to Control —ADDRESS menu” on page 59.