14
To
Stop play
Pause
Select a track
Find a point
in a track
Remove the
MD
Adjust the
volume
Do this
Press p.
Press ^ (P on the remote).
Press again to resume play.
Press )+ (to go forward) or
=0 (to go back) (+
or =
on the remote).
Press and hold on )+ or
=0 (0 or ) on the
remote) during play and release it
at the desired point.
Press 6.
Press VOL + or –.
Tips
• Inserting an MD turns on the power
automatically.
• You can start playing from the desired track.
Before pressing ^ (MD ( on the remote) in
step 2, press )+ or =0 (+
or = on
the remote) repeatedly until the desired track
appears.
• Pressing ^ (MD ( on the remote) when the
power is off automatically turns the power on and
starts MD playback if there is an MD in the MD
deck (One Touch Play).
• You can switch from another source to the MD
deck and start playing an MD just by pressing ^
(MD ( on the remote) (Automatic Source
Selection).
Notes
• If the MD reaches the end while you are locating a
point during sound monitoring, the deck stops.
• Tracks that are only a few seconds long may not
be serarched properly.
• If “OVER” appears while quickly locating a point
in a track, the MD has reached the end. Press
=0 on the MD deck (= on the remote).
Playing an MD (continued)
2 Press ^ (MD ( on the remote).
Playback starts.
To Next Page
Loading...
