Sony CMT-101 - To Stop Recording

35
3 When you record in monaural
sound, do as follows.
Though the sound is recorded in
monaural, the time you can record
becomes double. It is useful for
recording of the long playing.
1 While the MD deck is stopped, press
EDIT/NO on the MD deck until
“MONO REC?” appears.
2 Press YES on the MD deck.
“MONO REC Y/N” appears.
3 Press YES on the MD deck.
“MONO” appears.
When recording stops, the sound
becomes stereo sound automatically.
4 Press •REC on the MD deck.
The deck stands by for recording.
5 Press ^ on the MD deck (MD (
on the remote).
Recording starts.
6 Start playing the source to be
recorded.
To stop recording
Press p on the MD deck.
While “TOC” is flashing
Do not move the deck or pull out the mains lead to
ensure the complete recording. The deck updates
the Table of Contents (TOC) while “TOC” is
flashing.
Note
If you pause recording during CD recording, a track
number is recorded at that point. Also, note that the
tracks are recorded as a single track with a single
track number when:
• a single track of the same CD is recorded
repeatedly.
• two or more tracks with the same track number
from different CDs are recorded continuously.
Playing back tracks just recorded
You can listen to the tracks that have just
been recorded.
Press ^ (MD ( on the remote )
immediately after stopping recording.
Playback starts from the first track of the
material just recorded.
To play the first track of the MD after
recording
1Press p on the MD deck again after stopping
recording.
2Press ^ (MD ( on the remote).
Playback starts from the first track of the MD.
Note
If you press FUNCTION while recording, the
recording will be stopped.
Tips
• You can check the recording time or remaining
recordable time of the MD by pressing DISPLAY
while recording.
• You can record in monaural sound by using CD
synchro recording function. Do step 3 on this
page before pressing CD SYNC.