Sony Digital8 M2000 - Preparations for Check, Adjustment and Replacement of Mechanism Ae; Service Jigs and Tools

1. Preparations for Check, Adjustment and Replacement of Mechanism Block
Before Replacement, Check or Adjustment
* Refer to the “DISASSEMBLY” section of the SERVICE MANUAL of the respective models for details of removing cabinets and printed
wiring boards.
* When checking a mechanism ir making any adjustment to the mechanism or replacing mechanical parts, be sure to use the Mode Selector
Il and select the appropriate status of the mechanical deck such that the mechanical status is suitable for the desired work. Refer to section
“1-2. Mode Selector II Operating Procedure” for details on how to enter the mode shown in a rectangle [__] mode in the sequent sections
of this manual.
* Assemble and adjust the parts in the [USE] mode if any mode is not specified in this manual.
1-1. Service Jigs and Tools
[Name SSS*d;:CPart cote [vig inscription
Cleaning fluid Y-2031-001-0
Wiping cloth 7-741-900-53
Super-fine applicator
(made by Nippon Applicator (P752D))
ap,
bi w
Connery aa
ape path
aes
Mirror (small oval type) J-6080-840-A GD-2038 | Tape path
F
: NTSC : WRS-INP 8-967-995-02 . :
Alignment tape For tracking adjustment
PAL : WRS-1CP 8-967-995-07
-7_[FWDIRVS take-up torque casete | J-6080-824-4 | GB2086 |
[8 [Tape path screwdriver ————SSCSC~*d:«C ORIG | _—_—_——~«Ror tape guide adjustment
[9 [Adjustment remote commander (RMS upgraied)| 1-6082-053-8 | ____[ Tape path for sein the path ode NOW)
Floil grease 7-662-001-39 |
79049-330-4 [|
Mode Selector II J-6082-282-B {|
Mode Selector II conversion board J-6082-516-A
J-15 | Mode Selector I] ROM, Ver 1.6 . J-6082-314-E
J-16 | Thickness gauge 9-911-053-00
For capstan azimuth adjustment,
LS cam plate position adjustment
Other required equipment: Note: If the micro processor IC in the adjustment remote commander is
* Oscilloscope not the new micro processor (UPD7503G-C56-12), the pages cannot
« Analog tester (20 kQ) be switched. In this case, replace with the new micro processor (8-
759- 148-35).