Sony Digital8 M2000 - Rotary Switch, Cam Relay Gear; M Slide Plate Assembly, LS Arm Assembly, Cam Gear 2, GL Arm Assembly

4-19.M Slide Plate Assembly, LS Arm Assembly, Cam Gear 2, GL Arm Assembly
1.
1)
2)
3)
4)
5)
6)
D
Removal procedure
Remove the LS chassis block assembly. (Refer to 4-10.)
Remove the guide lock plate (S) (Refer to 4-17.)
Remove the relay gear @.
Remove the M slide plate assembly @ in the direction of the
arrow @),
Remove the LS arm assembly @) and LS arm roller @.
Remove the cam gear (2) ©.
Remove the GL arm assembly © from the lower side of the
cam relay gear (1) in the direction of the arrow ©.
Note: After removing the GL arm assembly, fix the guide gear (S/T)
assembly.
SETTING THE GEAR POSITION
©) Hole of mechanism
chassis
M slide plate
Rotary switch
Cam relay
gear (2)
Cam gear (2)
Cam relay
gear (1)
assembly
Guide gear
(T) assembly
Guide gear
(S) assembly C4 gear (1)
Guide gear é
(T) assembly |
~
Guide gear
(S) assembly
2. Attachment procedure
1)
3)
4)
5)
6)
71)
Attach the GL arm assembly © to the shaft so that the GL arm
assembly © is positioned under the cam relay gear (1).
Note: The in-phase markings of the guide gear (S/T) assembly and
GL arm assembly © must be aligned.
While aligning the cam gear (2) © with the dowel of the GL
arm assembly, attach the cam gear (2) ©.
Note: The in-phase markings of the cam relay gear (1), cam gear (1)
and cam gear (2) ® must be aligned.
Attach the LS arm roller @ to the LS arm assembly ®. While
aligning them with the cam groove on the cam gear (2) ©,
attach them.
Attach the M slide plate assembly @.
Attach the relay gear @.
Attach the guide lock plate (S). (Refer to 4-17.)
Attach the LS chassis block assembly to the mechaical chassis.
(Refer to 4-10.)
Note: Check that the in-phase marking of each gear is aligned.
LS arm assembly
(2) Remove the M slide
plate assembly in the
direction of the arrow®.
Relay gear
Coat the cam groove
with grease.
Cam gear (2)
(6) Remove the GL arm
assembly in the direction
of the arrow ®.
Cam relay gear (1)
Cam gear (1)
When attaching it, coat the hatched
portion with grease.