Sony Digital8 M2000 - Cassette Compartment Assembly Wuveseuesecveeseccseseccssecsessuveces

3-2. Cassette compartment assembly
1.
1)
2)
3)
4)
5)
.
Removal procedure
Set the mode to move up the cassette compartment
assembly @.
Remove the capstan flexible board and flexible wiring board
(FP-300) @ from the holders ®, ® and @ in the directions
of the arrows @, ® and ©.
Push the damper assembly @®) in the directions of the arrows
© and © and remove it from the notch of the LS chassis block
assembly.
Remove the two screws (camera pan2 main M1.4 x 1.6) @.
With the cassette compartment assembly @0 half opened, move
the face plate in the direction of the arrow © and remove it
from the grooves © and @ on the LS chassis block assembly.
Remove the cassette holder (S) © and cassette holder (T) ®
of the cassette compartment assembly @ from the groove on
the LS chassis block assembly.
eg, en
2. Attachment procedure
1)
2)
3)
4)
5)
6)
Set the mode.
Insert the cassette holder (S) of the cassette compartment
assembly and cassette holder (T) into the grooves on
both sides of the LS chassis block assembly.
While moving down the cassette compartment assembly (0,
lift up the face plate in the direction of the arrow © and keep
this status. Then, insert the face plate in the grooves © and @
on the LS chassis block assembly.
Tighten the two screws (camera pan2 main M1.4x1.6) ®.
Tightening torque: 0.078 + 0.01 Nem (0.8 + 0.1 kgfecm)
Move the damper arm of the damper assembly @ to the 4
o’clock position and insert the damper assembly into the hole
on the LS chassis block assembly and the dowel of the cassette
holder (T) ©.
Align the damper assembly @) with the notch of the LS chassis
block assembly and rotate the damper assembly @ in the
opposite direction to the arrow © to fix it.