Special Editing
3-20 Editing
Chapter 3 Editing
2 Press the AUTO EDIT button.
The edit starts.
3 While monitoring the picture,
when you reach the point you
want to set as the OUT point,
press the player side or recorder
side OUT button together with the
ENTRY/SHIFT button.
The point where the edit started is
set as the IN point, and the point
where the pressed the OUT and
ENTRY/SHIFT buttons is set as
the OUT point.
3-7-2 Continuous
Editing
When you execute multiple edits in
succession, you can edit from the
second time on by setting the IN and
OUT points of the player side only.
After execution of an edit, the recorder
returns automatically to the OUT
point. Therefore, the recorder side
OUT point of the current edit becomes
the IN point of the next edit.
Use the following procedure.
Recorder unit
Section edited in
previous edit
Player unit
OUT point of previous edit =
IN point of next edit
Section edited in next edit
1 Set the player side IN point.
2 Press the recorder side PREVIEW
button to conduct a preview.
3 Press the AUTO EDIT button.
The edit starts.
When the edit ends, the recorder
unit stops at the OUT point and
player unit stops 2 seconds after
the OUT point.
To stop an edit
Press the ENTRY/SHIFT button
together with the OUT button.
The edit ends, and the point where you
pressed the buttons becomes the OUT
point.
To abort an edit
Press the STOP button on the recorder
unit.
1
1 1
2
3
AUTO EDIT
AUDIO IN
TRIM
LIST MARK
GOOD
SHOT
ENTRY SHIFT
IN OUT
–+
TRIM
LIST MARK
GOOD
SHOT
ENTRY SHIFT
IN OUT
–+
DELETE
AUDIO IN
DELETE
PREVIEW REVIEW
OUT point
IN point
To Next Page
Loading...
