Connecting
to
the
AC
power
source
1 Insert the plug of the
AC
adaptor
into the DC
IN
24 V jack on the back
of the printer.
2 Connect one plug of the AC power
cord to the connector of the AC
adaptor and the other plug to the
wall outlet.
-
• Do not place the printer in an unstable location
such as on a wobbly table.
• Leave enough room around the printer. The print
paper emerges from the back a few times during
printing. Keep
10
em (13/32 inches)
or
more space
at the rear
of
the printer.
• Connect the AC adaptor to an easily accessible
wall outlet close by.
If
trouble occurs while using
the adaptor, immediately shut
off
the power by
disconnecting the plug from the wall outlet.
• Do not short the plug
of
the AC adaptor with a
metallic object, as this may cause a malfunction.
• Do not use the AC adaptor placed in a narrow
space, such as between a wall and furniture.
• When you have finished using the AC adaptor,
disconnect the AC power cord from the
DC IN 24 V jack
of
the printer and from the AC
power sources.
• The printer
is
not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the printer itself has been turned off.
10cm
(13/32
inches)
To use your Printer
abroad-
Power sources
You can use your Printer and the AC Adaptor
(supplied) in any country or region where the
power supply is within 100 V
to
240 V AC,
50/60 Hz. Use a commercially available AC
plug adaptor [a), if necessary, depending on the
wall outlet (wall socket) [b).
IAC-S2422
r=o=.~.~
[8]
[b]
Do not use an electronics transformer (travel
converter), as this may cause a malfunction.
To Next Page
Loading...
Need help?
General
