Sony DSC-W270 - Troubleshooting

Troubleshooting
If you experience trouble with the camera, try the following solutions.
O Check the items below, and refer to "Cyber-shot Handbook" (PDF).
It a code such as "C/E:[-II-I:[-II-I" appears on the screen, refer to "Cyber-shot
Handbook."
v
O Removethebatterypack,waitfor aboutone minute,re-insertthe battery
pack,thenturnon thepower.
v
O Initialize thesettings(page47).
O ConsultyourSony dealeror localauthorizedSonyservicefacility.
On repairing cameras with internal memory or Music files function included, data in the
camera may be checked on minimum necessity to verify and improve the malfunction
symptoms. Sony will not copy or save any of those data.
_ ,'t_iT! IIfl:.l','_:=_i
Cannot insert the battery pack.
• Insert the battery pack correctly by pushing the battery eject lever (page 14).
Cannot turn on the camera.
• After inserting the battery pack into the camera, it may take a few moments for the camera to
power up.
• Insert the battery pack correctly (page 14).
• The battery pack is discharged. Insert a charged battery pack (page 12).
• The battery pack is dead. Replace it with a new one.
• Use a recommended battery pack.
The power turns off suddenly.
• Depending on the camera and battery temperature, the power may turn off automatically to
protect the camera. In this case, a message is displayed on the LCD screen before the power
turns off.
• If you do not operate the camera for about three minutes while the power is on, the camera
turns off automatically to prevent wearing down the battery pack. Turn on the camera again
(page 16).
• The battery pack is dead. Replace it with a new one.
g-
53 GB