Sony HCD-441 - Playing Back Tapes (on either Deck A or B); Selecting Tape Mode; Loading Cassette Tapes; Dolby NR Setting

Playing Back Tapes (on either Deck A or B)
This section describes about a basic playback operation on either deck A or B.
‘3 Press DOLBY NR to select the DOLBY NR
setting.
DOLBY NR
20
a
Pee
4 Press [> to start playback.
When the tape ends, playback automatically stops.
To stop playback, rewinding or fast forwarding,
press @.
To pause, press il.
To resume playback, press §8 again or >.
To rewind the tape, press <4.
To fast-forward the tape, press PP.
Notes
* During playback or recording on a deck, do not operate
"TAPE" the display. the other deck. (When both decks A and B are in playback
BEER Heer vane mode, only playback from deck A will be audible.)
* Before turning the power off, be sure to stop playback or
recording by pressing @.
2 Press & to open the cassette compartment,
insert the tape with the side to be played What is the Dolby NR* system?
back facing you and close the cassette
compartment. Dolby NR (noise reduction) system reduces tape hiss noise in
EJECT low-level, high-frequency signals. The system boosts these
signals in recording and lowers them in playback.
When listening to a tape recorded with Dolby NR, set
DOLBY NR to ON.
* Dolby noise reduction manufactured under license from Dolby
Laboratories Licensing Corporation.
"DOLBY" and the double-D symbol O00 are trademarks of Dolby
Laboratories Licensing Corporation.
13