7
HCD-C450
SECTION 2
DISASSEMBLY
Note: Follow the disassembly procedure in the numerical order given.
• The equipment can be removed using the following procedure.
2-1. Case (Top)
POWER BOARD
MECHANISM DECK (CDM53K-DVBU7)
FITTING BASE (MAGNET) ASSEMBLY
FITTING BASE (GUIDE) ASSEMBLY,
RACKET (CHASSIS)
DVD BASE UNIT (DVBU7)
TRAY (240)
LOAD MOTOR BOARD, MOTOR (LOADING) ASSEMBLY (M702)
STOCKER SECTION
GEAR (GEAR A), GEAR (GEAR B), GEAR(U/D SLIDER)
GEAR (CHUCKING)
SLIDER (SELECTION), TENSION SPRING (SHUTTER),
SLIDER (SHUTTER)
CHASSIS (MOLD B) SECTION
OPTICAL PICK UP (KHM-240AAA)
CLAMP MOTOR BOARD, MOTOR (CLAMP) ASSEMBLY
RF-240 BOARD
TUNER UNIT
CASE (TOP)
FRONT PANEL SECTION
SET
4
case
3
four screws,
+BVTP
(3
×
8)
1
two case screws
2
two case screws
To Next Page
Loading...
