2
HCD-DV2D
Ver. 1.2
On HCD-DV2D,these are three kinds POWER boards for E2, E3, E51, Singapore, Taiwan
models, for US, Canadian models and for AEP, UK, Russian, Korean, Australian models.
This SUPPLEMENT-1 describes the POWER board for AEP, UK, Russian, Korean,
Australian models.
Refer to the following Circuit Board Location on a location of the POWER board.
Refer to original service manual (9-879-536-0[ ]) for other information.
POWER board
AMP board
MPEG board
HP board
For Schematic Diagrams.
Note:
• All capacitors are in µF unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and
1
/
4
W or less unless otherwise
specified.
• C : panel designation.
• A : B+ Line.
•Abbreviation
AUS: Austrralian model.
KR : Korea model.
RU : Russian model.
For Printed Wiring Boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : Pattern from the side which enables seeing.
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in block.)
Caution:
Pattern face side: Parts on the pattern face side seen from
(Side A) the pattern face are indicated.
Parts face side: Parts on the parts face side seen from
(Side B) the parts face are indicated.
Note:
The components identi-
fied by mark 0 or dot-
ted line with mark 0 are
critical for safety.
Replace only with part
number specified.
Note:
Les composants identifiés
par une marque 0 sont cri-
tiques pour la sécurité.
Ne les remplacer que par une
piéce portant le numéro
spécifié.
NOTE
•Abbreviation
E2 : 120 V AC area in E model.
E3 : 240 V AC area in E model.
E51 : Chilean and Peruvian model.
To Next Page
Loading...
