C:\4692676112\4692676112ILCE9UC2\01GB-ILCE9UC2\030BAS.indd
2017/03/15 14:08
ILCE-9
4-692-676-11 (2)
GB
103
Shooting
Note
• The longer the exposure time, the more noise will be visible on the image.
• After shooting, noise reduction will be done for the same amount of time
that the shutter was open. However, you cannot shoot any more while noise
reduction is in progress.
• You cannot set the shutter speed to [BULB] in the following situations:
– [Auto HDR]
– [Picture Effect] is set to [Rich-tone Mono.]
– When [Drive Mode] is set to the following:
– [Cont. Shooting]
– [Self-timer (Cont)]
– [Cont. Bracket]
– [
Shutter Type] is set to [Electronic Shut.]
If you use the above functions when the shutter speed is set to [BULB], the
shutter speed is temporarily set to 30 seconds.
• If you set [Drive Mode] to [Cont. Shooting] and [
Shutter Type] to [Auto] or
[Electronic Shut.] when the shutter speed is set to [BULB], the shutter speed
will be temporarily set to 1/8 seconds.
/ Recall
Allows you to shoot an image after recalling often-used modes or camera
settings registered with [
/ Memory] in advance.
1
Set the mode dial to 1, 2, or 3 (Memory recall).
2
Press the center of the control wheel to confirm.
• You can also recall registered modes or settings by selecting MENU
(Camera Settings 1) [ / Recall].
To Next Page
Loading...
