Sony ILCE-9 - Flash Comp

ILCE-9
4-692-676-11 (2)
C:\4692676112\4692676112ILCE9UC2\01GB-ILCE9UC2\030BAS.indd
2017/03/15 14:08
GB
134
Wireless: Using a wireless flash creates a shading effect that gives the
subject a more 3D appearance than when using an attached flash.
This mode is effective when you attach a remote control-compatible
external flash (sold separately) to the product, and shoot with a wireless
flash (sold separately), placed away from the product.
Note
• The default setting depends on the shooting mode.
• Some [Flash Mode] settings are not available, depending on the shooting
mode.
Flash Comp.
Adjusts the amount of flash light in a range of –3.0EV to +3.0EV.
Flash compensation changes the amount of flash light only. Exposure
compensation changes the amount of flash light along with the change of
the shutter speed and aperture.
MENU  (Camera Settings 1)  [Flash Comp.]  desired
setting.
• Selecting higher values (+ side) makes the flash level higher, and lower
values (- side) makes the flash level lower.
Note
• [Flash Comp.] does not work when the shooting mode is set to the following
modes:
– [Intelligent Auto]
• The higher flash effect (+ side) may not be visible due to the limited amount
of flash light available, if the subject is outside the maximum range of the
flash. If the subject is very close, the lower flash effect (- side) may not be
visible.
• If you attach an ND filter to the lens or attach a diffuser or a color filter to the
flash, the appropriate exposure may not be achieved and images may turn
out dark. In this case, adjust [Flash Comp.] to the desired value.