C:\4692676112\4692676112ILCE9UC2\01GB-ILCE9UC2\030BAS.indd
2017/03/15 14:08
ILCE-9
4-692-676-11 (2)
GB
111
Shooting
Zebra
The zebra pattern will appear over part of an image if the brightness level
of that part meets the IRE level that you set. Use this zebra pattern as a
guide to adjust the brightness.
MENU (Camera Settings 2) [Zebra] desired setting.
Off: Does not display the zebra pattern.
70/75/80/85/90/95/100/100+/Custom 1/Custom 2: Adjusts the
brightness level.
Hint
• You can register values to check the correct exposure or overexposure as
well as the brightness level for [Zebra]. The settings for correct exposure
confirmation and overexposure confirmation are registered to [Custom 1] and
[Custom 2] respectively in the default settings.
• To check the correct exposure, set a standard value and the range for the
brightness level. The zebra pattern will appear on areas that fall within the
range you set.
• To check the overexposure, set a minimum value for the brightness level. The
zebra pattern will appear over areas with a brightness level equal to or higher
than the value you set.
Note
• The zebra pattern is not displayed on devices connected via HDMI.
To Next Page
Loading...
