Sony ILCE-9 - Page 228

ILCE-9
4-692-676-11 (2)
C:\4692676112\4692676112ILCE9UC2\01GB-ILCE9UC2\110TBS.indd
2017/03/15 14:08
GB
228
Shooting still images/movies
No images appear on the viewfinder.
• [FINDER/MONITOR] has been set to [Monitor (Manual)]. Change
[FINDER/MONITOR] to [Auto] or [Viewfinder (Manual)] (page 176).
• Bring your eye close to the viewfinder.
• When the monitor is pulled out, the eye sensor of the camera will
not detect you are approaching even if [FINDER/MONITOR] is set to
[Auto]. The image will continue to be displayed on the monitor.
The shutter cannot be released.
• You are using a memory card with a write-protect switch or an
accidental erasure prevention switch, and the switch is set to the
LOCK position. Set the switch to the record position.
• Check the free capacity of the memory card.
• The lens is not attached properly. Attach the lens properly
(page43).
• When attaching the product to an astronomical telescope, etc., set
[Release w/o Lens] to [Enable] (page212).
• Set [Release w/o Card] to [Enable] (page212). However, when no
memory card has been inserted, the images shot will not be saved.
• The self-timer has been activated.
Recording takes a long time.
• The noise reduction function is processing an image. This is not a
malfunction.
• You are shooting in RAW mode. Since RAW data files are large, RAW
mode shooting may take time.
• The [Auto HDR] function is processing an image.
The same image is captured multiple times.
• The drive mode has been set to continuous shooting or bracket
shooting. Set the drive mode to [Single Shooting] (page79).