MJ620
(E) i
Contents
1. Notes to Users ...........................................................1
1-1. General precautions ..........................................................................................1
1-2. Precautions ........................................................................................................1
1-3. Installation ........................................................................................................1
2. Introduction ...............................................................2
3. Operation ...................................................................3
3-1. Names of each part ...........................................................................................3
3-2. Switches ............................................................................................................4
3-3. Number of divisions and output phase difference ............................................6
3-3-1. Setting the number of divisions .....................................................7
3-3-2. Output phase difference .................................................................7
3-3-3. Direction switching ........................................................................8
3-4. Using the reference point ..................................................................................9
3-4-1. Principles of reference point output ............................................... 9
3-4-2. Setting the reference point output signal width ...........................10
3-4-3. Adjusting the reference point .......................................................10
3-5. Setting the minimum phase difference ...........................................................12
3-6. Maximum response speed...............................................................................12
3-7. Alarm signal....................................................................................................14
3-7-1. Alarm reset mode ......................................................................... 14
3-8. Setting the hysteresis ......................................................................................15
3-9. Power supply...................................................................................................16
3-10. Mounting the interpolator ...............................................................................17
4. Input and Output Connectors ................................18
4-1. Encoder signal input connector.......................................................................18
4-2. Output connector.............................................................................................19
4-2-1. Output connector.......................................................................... 19
4-2-2. Input and output cable specifications...........................................20
5. Specifications ..........................................................21
5-1. General specifications .....................................................................................21
6. Dimensions ..............................................................23
To Next Page
Loading...