Sony PDW-700 - Warning Messages

Operation Warnings
191
Chapter 9 Maintenance
Warning messages
Error**-**
a)
Warning
indication
State WARNING
indicator
Warning sound REC/TALLY BATT
—— —
Problem VDR operation Action to take
Recording error Recording stops. Turn off the power and
consult a Sony service
representative.
MEM Full!
Warning
indication
State WARNING
indicator
Warning sound REC/TALLY BATT
——
b)
b)
b)
—
Problem VDR operation Action to take
Shockproof memory overflow Recording continues but may be
substandard.
Protect the unit from shocks
and vibrations.
ILL REC!
Warning
indication
State WARNING
indicator
Warning sound REC/TALLY BATT
——
b)
b)
b)
—
Problem VDR operation Action to take
Input sync error Recording continues but may be
substandard.
Turn off the power and
contact a Sony service
representative. (This
indication may be given
momentarily when a
GENLOCK signal is
connected or disconnected,
but this does not indicate a
problem.)
Disc Error!
Warning
indication
State WARNING
indicator
Warning sound REC/TALLY BATT
——
b)
b)
b) —
Problem VDR operation Action to take
A disc defect was detected. Recording continues, avoiding the
defect, but may be substandard.
If defects are detected
repeatedly, exchange the disc.
HUMID!
Warning
indication
State WARNING
indicator
Warning sound REC/TALLY BATT
——
b)
b)
c)
b)
—
Problem VDR operation Action to take
Condensation on the optical
pickup
Recording/playback continues but
stops when an error occurs on the
drive.
Stop recording/ playback, turn
off the power, then turn it on
again, and wait until the
HUMID indicator disappears.