Setup Menu List
57
Menu Configuration and Detailed Settings
Battery Alarm
Setting the low
power alarm
Low BATT
5% / 10% / 15% / ... / 45% /
50%
Set the battery level at which the Low BATT warning is
generated (in steps of 5%).
BATT Empty
3% to 7% (3%)
Set the battery level at which the BATT Empty warning is
generated.
DC Low Volt1
11.5 V to 17.0 V (11.5 V)
Set the DC IN voltage at which the DC Low Volt1 warning is
generated.
DC Low Volt2
11.0 V to 14.0 V (11.0 V)
Set the DC IN voltage at which the DC Low Volt2 warning is
generated.
Battery INFO
Showing
information
regarding the
battery pack
(display only)
Type The type (product name) is displayed.
MFG Date The date of manufacture is displayed.
Charge Count The accumulated number of times of charge/discharge is
displayed.
Capacity The estimated total capacity of full charge is displayed.
Voltage The current output voltage is displayed.
Remaining The current remaining level is displayed.
Trigger Mode
Setting for
operating an
external recording
device connected
via the i.LINK
connector (FAT
only)
[M]
Internal / Both / External [Internal]: To activate recording start/stop operations only for
an SxS memory card in a built-in slot.
[Both]: To activate recording start/stop operations both for an
SxS memory card in a built-in slot and the external
recording device connected via the i.LINK connector.
[External]: To activate recording start/stop operations only
for the external recording device connected via the
i.LINK connector.
System
Country
NTSC Area / NTSC(J) Area /
PAL Ar e a
Select the area of use and setup ON/OFF setting.
[NTSC Area]: Setup ON
[NTSC(J) Area]: Setup OFF
[PAL Area]: Setup OFF
Note
The default setting is different among the sales areas.
United States and Canada: NTSC Area
Other areas: PAL Area
F.Sys.
UDF / exFAT / FAT
Switch the file system between UDF/exFAT/FAT.
HD/SD
HD / SD
Switch between HD Mode and SD Mode for recording/
playback.
XAVC/MPEG2
XAVC / MPEG2
Switch between the XAVC and MPEG2 formats during
exFAT and HD mode.
OTHERS
Menu items Subitems and setting values Contents
To Next Page
Loading...
