Useful Functions
26
Recording
Deleting the OK mark
Press the assignable button to which you assigned
the [OK Mark] function, and select [Execute].
While standing by to record, you can also delete
the OK mark from the clip with the last-added OK
mark.
Adding or deleting the OK mark to or from clips
before the last one
Make changes via the thumbnail screen (page
39).
The recorder has five assignable buttons (page 7)
to which you can assign various functions for
convenience.
To change functions
Use [Assign Button] (page 56) in the [OTHERS]
menu.
The assigned functions can be viewed on the
Button/Remote status screen (page 44).
Clips are normally created individually for each
time you start and stop recording, but you can also
continue recording to a single clip regardless of
the number of times you start and stop recording
by using the Clip Continuous Recording function,
which will add recordings to the same clip until
the function is disabled or turned off.
This is convenient for when you do not want to
create a large number of short clips, or when you
do not want to be restricted by a maximum
number of clips.
A recording start mark is added to each point at
which you resume recording, making it easy to
search for each point.
Preparatory settings
Set [Clip Cont. Rec Setting] (page 51) in the
[VIDEO SET] menu to [On].
When you set [Setting] to [On] the [Clip
Continuous Recording] function is enabled, and
“CONT” appears on the screen (page 9).
You can also assign [Clip Continuous Rec] to an
assignable button (page 26), and set to [On]/[Off]
by pressing the button.
Notes
• Clip Continuous Recording cannot be used while
recording.
• This function cannot be used with FAT.
Performing clip continuous recording
Press and hold the REC button, then press
the PLAY/PAUSE.
When recording starts, the “CONT” indication on
the screen changes to “zREC” (with z in red).
To pause recording, press the PLAY/PAUSE
button. To resume, press and hold the REC
button, then press the PLAY/PAUSE button.
Pressing the STOP/EE button closes the clip. In
clip continuous mode, the “CONT” indicator
flashes if there is no continuous clip.
When operating the IR Remote Commander,
press the START/STOP button to start recording,
and press the START/STOP button or PAUSE
button to stop recording. To resume, press the
START/STOP button again. Pressing the STOP
button will close the clip.
Notes
• If you remove the SxS memory card or the battery
while recording or standing by to record (the “CONT”
indication appears), the SxS memory card must be
restored. Only remove the SxS memory card after Clip
Continuous Recording is complete. If “CONT” is
flashing (1 time per second), you can remove the SxS
memory card.
• Record for at least 2 seconds before you stop
recording.
• If [Input Source Select] is set to [i.LINK], the [Clip
Continuous Recording] function is disabled.
To disable Clip Continuous Recording mode
While standing by to record, set [Clip Cont. Rec
Setting] (page 51) in the [VIDEO SET] menu to
[Off].
Restricted operations
If you perform any of the following operations
while recording or standing by to record, 1
continuous clip will not be created. The next time
you start recording, a new clip will be created.
• Performing clip operations (locking, deleting,
or changing the names of clips).
• Switching the memory card slot.
• Changing the recording format.
• Setting the power button to OFF.
• Displaying the thumbnail screen.
• Playing clips.
Assignable Buttons
Clip Continuous Recording
UDF
exFAT
To Next Page
Loading...
