You can use the AUTO CAL menu to make
various adjustments for Auto Calibration
settings and
to
name the position.
Select "A. CAL"
in
the amplifier menus. For
details on adjusting the parameters, see "Using
the setting menu" (page 71) and "Overview
of
the menus" (page 72).
• START
•
CAL
TYPE*
Lets you select the Auto Calibration type for
each seating position. For details, see step 4
of
"3: Confirming/saving the measurement
results" (page 36).
*
You
can select this parameter only when you have
performed the Auto Calibration and saved the
settings.
• POSITION
You can register three patterns as position 1,2,
3, depending on the seating positions, listening
environment, and measurement conditions.
If
you do not select the position number, the
Auto Calibration result will automatically save
as POS 1 (initial setting).
To
register more than one set
of
settings for the listening
environment
You can select the seating position you want
and register the measurement results
of
the
Auto Calibration for that seating position.
1 Press AMP MENU.
2 Press
+/+
repeatedly to select
"A. CAL", then press
@
or
•.
3 Press
+/+
repeatedly to select
"POSITION", then press
@
or
•.
4 Press
+1+
repeatedly to select the
position (POS
1,
2,
3) for which you
want to register the measurement
results, then press
@.
5 Press
+1+
repeatedly to select
"START', then press
@ to perform
Auto Calibration.
For details, see "2: Performing Auto
Calibration" (page 35).
The measurement results
is
registered
as
the position you selected
in
step
4.
6 Repeat steps 1 to 5 to register another
seating position.
To
select the registered seating
position
1 Press AMP MENU.
2 Press
+1+
repeatedly to select
"A. CAL", then press
@
or
•.
3 Press
+1+
repeatedly to select
"POSITION", then press
@ or
•.
4 Press
+1+
repeatedly to select position
(POS
1,2,
3) you want, then press
@.
The registered seating position
is
selected.
To
exit
the
menu
Press AMP MENU.
• NAME
IN
(Naming
position)
You can rename the position name.
1 Select the position (POS 1,
2,
3) for
which you want to name.
2 Press
+1+
repeatedly to select "NAME
IN", then press @
or
•.
The cursor flashes and you can select a
character.
3 Press
+1+
to select a character, then
press
+1. to move the cursor to the
next position.
If you made a mistake
Press +1. until the character you want
to
change flashes, then press
+/+
to select the
correct character.
•
"'0
(i;
'C
C)
""l
::::J
(Q
-
:::T
CD
:II
CD
o
CD
<
CD
""l
continued-----
To Next Page
Loading...
