You can adjust the level
of
each speaker.
These settings are applied to all sound fields.
•
T.
TONE
Lets you adjust the speaker levels while
listening to the test tone from your listening
position.
• OFF
The test tone is turned off.
•
AUTO
•••
*
The test tone is output from each speaker in
sequence.
*
•••
represent a speaker channel.
Adjusting the speaker level
You can adjust each speaker's level using the
following parameters.
Forfront left/right speakers, you can adjust the
level from
-10.0
dB to +10.0 dB in 0.5 dB
steps. For other speakers, you can adjust the
level from
-20.0
dB to +10.0 dB in 0.5 dB
steps.
• FL LVL
• FR
LVL
•
CNT
LVL
• SL LVL
•
SR
LVL
• SB
LVL
• SBL
LVL
• SBR
LVL
• LH LVL
• RH LVL
•
SW
LVL
Note
Depends on the speaker pattern setting, some
parameters may not
be
available.
76
GB
•
D.
RANGE
Lets you compress the dynamic range
of
the
soundtrack. This may be useful when you want
to watch movies at low volumes late at night.
Dynamic range compression is possible with
Dolby Digital sources only.
•
CaMP.
MAX
The dynamic range
is
compressed
dramaticall
y.
•
CaMP.
STD
The dynamic range
is
compressed
as
intended by the recording engineer.
• COMP.AUTO
The dynamic range is compressed
automatically.
•
CaMP.
OFF
The dynamic range is not compressed.
Tip
Dynamic range compressor lets you compress the
dynamic range
of
the soundtrack based on the
dynamic range information included in the Dolby
Digital signal.
"COMP. STD"
is
the standard setting, but it only
enacts light compression. Therefore, we recommend
using the "COMP. MAX" setting. This greatly
compresses the dynamic range and lets you view
movies late at night at low volumes. Unlike analog
limiters, the levels are predetermined and provide a
very natural compression.
To Next Page
Loading...
