•
SB
DIST.
•
Sl
DIST.
•
SBl
DIST.
• CNT DIST.
Lets you set the distance from your listening
position to the center speaker.
»
0.
<
Q)
:::J
(')
(I)
0.
o
"C
(I)
"'"
Q)
~
o
:::J
en
-
• SW DIST.
Lets you set the distance from your listening
position
to
the subwoofer.
• SBR DIST.
Lets you set the distance from your listening
position to the surround back speakers.
•
RH
DIST.
Lets you set the distance from your listening
position
to
the front high speakers.
•
lH
DIST.
•
FR
DIST.
Lets you set the distance from your listening
position to the front speakers.
If
both front speakers are not placed an equal
distance from your listening position, set the
distance to the closest speaker.
•
SR
DIST.
Lets you set the distance from your listening
position to the surround speakers.
Notes
• Depends on the speaker pattern setting. Some
parameters may not
be
available.
• This function does not work in the following cases.
- Signals with a sampling frequency
of
more than
96 kHz are being received.
- Analog Direct
is
selected.
Tip
The
"LARGE"
and "SMALL" settings for each
speaker determine whether the internal sound
processor will cut the bass signal from that channel.
When the bass
is
cut from a channel. the bass
redirection circuitry sends the corresponding bass
frequencies to the subwoofer
or
other
"LARGE"
speakers.
However, since bass sounds have a certain amount
of
directionality, it
is
best not to cut them,
if
possible.
Therefore, even when using small speakers, you can
set them to
"LARGE"
if
you want to output the bass
frequencies from that speaker. On the other hand. if
you are using a large speaker, but prefer not to have
bass frequencies output from that speaker, set it to
"SMALL".
If
the overall soundlevel is lowerthan you prefer, set
all speakers to
"LARGE".
If
there is not enough
bass, you can use the equalizer to boost the bass
levels. For details, see page 80.
•
SB
ASGN
•
SPKB
If you connect an additional front speaker
system to the SPEAKERS SURROUND
BACKIFRONT HIGH/BI-AMP/FRONT B
terminals, select "SPK B".
• BI-AMP
If
you connect front speakers to the
SPEAKERS SURROUND BACKIFRONT
HIGH/BI-AMP/FRONT B terminals using a
bi-amplifier connection, select "BI-AMP".
• OFF
If
you connect sun-ound back speakers or
front high speakers to the SPEAKERS
SURROUND BACKIFRONT HIGH/BI-
AMP/FRONT B terminals, select "OFF".
Note
When you change the connection from bi-amplifier
or
speaker front B to surround back
or
front high
speakers connection, set
"SB
ASGN" to
"OFF',
then perform the Auto Calibration again (page 35).
•
Fl
DIST.
.DIST.UNIT
Lets you select the unit
of
measure for setting
distances.
• METER
The distance is displayed in meters.
• FEET
The distance is displayed
in
feet.
continued-----------
To Next Page
Loading...
