On
placement
• Place the receiver in a location with adequate
ventilation to prevent heat buildup and
prolong the life
of
the receiver.
• Do not place the receiver near heat sources.
or
in
a place subject to direct sunlight.
excessive dust.
or
mechanical shock.
•
Do
not place anything on top
of
the cabinet
that might block the ventilation holes and
cause malfunctions.
•
Do
not place the receiver near
equipment
such as a TV. VCR.
or
tape deck.
(IJ
the
receiver is being used in combination with a
TV,
VCR,
or
tape deck,
and
is
placed too
close to that
equipment,
noise may result.
and picture quality may suffer. This is
especially likely when using an indoor
antenna (aerial). Therefore, we
recommend
using an
outdoor
antenna (aerial).)
• Use caution when
placing
the receiver on
surfaces that have been specially treated
(with wax, oil, polish, etc.) as staining
or
discoloration
of
the surface may result.
On
operation
Before
connecting
other
components,
be sure
to turn
off
and unplug the receiver.
On
cleaning
Clean the cabinet. panel. and controls with a
soft cloth slightly
moistened
with a mild
detergent solution.
Do
not use any type
of
abrasive pad, scouring powder.
or
solvent.
such as alcohol
or
benzine.
On S-AIR function
• As the
S-AIR
product(s) transmits sound by
radio waves, sound may skip when radio
waves are obstructed. This
is
a characteristic
of
radio
waves
and is not malfunction.
• As the
S-AIR
product(s) transmits sound by
radio waves,
equipment
that generates
electromagnetic energy. such as a
microwave
oven. may interfere with sound
transmission.
• As the
S-AIR
product(s) uses the radio
waves that share the
same
frequency as
other
wireless systems. such as wireless LAN
or
Bluetooth devices. interference
or
poor
transmission may result. In this case, take
the following steps to
enhance
the
transmission
of
signal:
- Avoid placing the
S-AIR
product(s) near
other
wireless systems.
- Avoid using the
S-Air
product(s) and the
other
wireless systems at the same time.
-
The
transmission
may
be improved by
changing
the transmission channel
(frequency)
of
the
other
wireless
system(s). For details, refer to the
operating
instructions
of
the other wireless
system(s).
•
The
transmission distance differs depending
on the usage environment. Find a location
where transmission
between
the S-AIR main
unit and sub unit is
most
effective, and
install the
S-AIR
main unit and sub unit
there.
• Place the
S-AIR
product(s) on the stable
surface
off
the floor.
•
Poor
transmission may
occur
and the
transmission distance
may
be too short if the
following conditions exist:
- There
is
a waillfloor made
of
reinforced
concrete
or
stone between the S-AIR
product(s).
- There is an iron divider/door
or
furniture/
electric product made
of
fireproof glass.
metaL etc
..
between the S-AIR product(s).
If
you
have
any
questions
or
problems
concerning
your
receiver. please consult
your
nearest
Sony
dealer.
89
GB
-
»
c.
c.
;:;:
o
:]
Q)
:]
-
o
--e
3
Q)
=:
o
:]
To Next Page
Loading...
