There is no sound from digital sources
(from COAXIAL or OPTICAL input jack).
• Check that the INPUT MODE is not set to
"ANALOG" (page 68).
• Check that the Analog Direct function
is
not selected.
• Check that the
"A.
ASSIGN" function
is
not used to reassign the audio input
of
another source to the selected input (page
68).
• Set "ARC" to "ARC OFF" when no sound
is
output from TV OPTICAL IN
jack
during
TV
input (page 83).
The left and right sounds are
unbalanced or reversed.
•
Check
that the speakers and components
are connected correctly and securely.
• Adjust the level parameters using the
LEVEL
menu.
There is no sound from the subwoofer.
• Check that the subwoofer
is
connected
correctly and securely.
• Make sure you have turned on your
subwoofer.
• Depending on the selected sound field, no
sound output from the subwoofer.
• When all speakers are set to
"LARGE'
and
"NE06
CIN" or
"NE06
MUS"
is
selected, there
is
no sound from the
subwoofer.
• Check "PATTERN" setting (page 77).
The surround effect cannot be
obtained.
• Make sure you have selected the sound
field for movie or music mode (page
50 or
51).
• Sound fields do not function for signals
with a sampling frequency
of
more than
48 kHz.
There is severe hum or noise.
•
Check
that the speakers and components
are connected securely.
•
Check
that the connecting cords are away
from a transformer or motor, and at least
IO
feet
(3
meters) away from a TV set or
fluorescent light.
• Move your audio components away from
the
TV.
• The plugs and jacks are dirty. Wipe them
with a cloth slightly moistened with
alcohol.
There is no sound, or only a very low-
level sound
is
heard from the center/
surround/surround back/front high
speakers.
• Select a
CINEMA
STUDIO EX mode
(page
50).
•
Check
that the speaker settings are
appropriate using the AUTO
CAL
menu or
"PATTERN"
in
the SPEAKER menu.
Then check that sound
is
output from each
speaker correctly,
using'T
TONE'"
in
the
LEVEL
menu.
• Adjust the speaker level (page
40).
Dolby Digital or DTS multi channel
sound is not reproduced.
• Check that the DVD, etc. you are playing
is
recorded in Dolby Digital or DTS
format.
• When connecting the DVD player, etc
..
to
the digital input jacks
of
this receiver.
check the audio setting (the settings for the
audio output)
of
the connected component.
For example, when connecting the
"PlayStation 3", set the
BD/DVD audio
output format to "Bitstream" on the
"PlayStation 3".
• Set "AUDIO.OUT" to "AMP" in the
HDMI
menu.
Recording cannot be carried out.
• Check that the components are connected
correctly.
• Select the source component using the
input buttons (page 42).
-
»
c.
c.
::;:
o·
;j
~
;j
-
o
...
3
~
-
o·
;j
con
ffn
ued-----------
91
GB
To Next Page
Loading...
