The ROS information that you want
does not appear.
*
• Contact the radio station and find out
whether they actually provide the service
in
question.
If
so, the service may be
temporarily out
of
order.
*Models
of
area code AU I, SA2.
TW2
only.
The source sound input to the HOMI
jack
is
not output from the receiver or
the TV speaker.
• Check the HDMI connection (page 24).
•
You
cannot listen to the Super Audio
CD
by connecting HDM!.
• Depending on the playback component,
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
• Be sure to use a High Speed
HDMI
cable
when you view images or listen to sound
during Deep Color (Deep Colour)
transmission.
The source image input to the HOMI
jack
is
not output from the
TV.
•
Check
the HDMI connection (page 24).
• Depending on the playback component.
you may need to set up the component.
Refer to the operating instructions
supplied with each component.
• Be sure
to use a High Speed
HOMI
cable
when you view images
or
listen to sound
during Deep Color (Deep Colour)
transmission.
The Control for HOMI function does not
work.
• Check the HDMI connection (page 24).
• Make sure
"CTRL.HDMI"
is
set to
"CTRL
ON"
in
the HOMI menu.
• Make sure the connected component
is
compatible with the Control for HOMI
function.
• Check the Control for HOMI settings on
the connected component. Refer to the
operating instructions
of
the connected
component.
• Repeat the procedures
of
"Preparing for
the
"BRA
VIA" Sync"
if
you change the
HDMI connection, connect/disconnect the
AC power cord (mains lead),
or
when
there
is
a power failure (page 55).
No sound
is
output from the receiver
and TV speaker while using the System
Audio Control function.
• Make sure the
TV
is compatible with the
System Audio Control function.
• If the
TV
does not have System Audio
Control function, set the "AUDIO.
OUT"
settings in HOMI menu to
-
"TV
+AMP"
if you want to listen to the
sound from the
TV
speaker and receiver.
- "AMP"
if
you want to listen to the sound
from the receiver.
• When you connect the receiver to a video
component (projector, etc.), sound may
not be output from the receiver.
In
this
case, select "AMP".
• If you cannot listen to the sound
of
a
component connected to the receiver
- Change the input
of
the receiver to
HDMI when you want to watch a
program on a component connected via
HDMI connection to the receiver.
- Change the
TV
channel when you want
to watch a TV broadcast.
- Select the component
or
input you want
to watch when you watch a program on
the component connected to the
TV.
Refer to the operating instructions
of
the
TV on this operation.
-
»
a.
a.
::J
-
o
.,
3
D)
=:
o
::J
conffnued-----------
To Next Page
Loading...
