Sony Trimaster EL BVM-E250 - Page 63

63
Function Setting Menu
Chapter 3 Menu
Gamut Error Display
OSD Notification Sets whether or not to display the message of an error notification on the screen when the
error is detected ([Off] or On).
OSD Notification Reset Sets the method to reset the error detection mode.
[Auto]: Resets automatically after detecting the error.
Manual: Resets manually.
To reset the error detection, select Error Notify Clear (page 69) in the Function Switch
menu of the Function Setting menu or set Error Notify Clear to on by pressing the Error
Notify Clear button
1)
of the controller.
1) Error Notify Clear is assigned to a function button of the controller in the Function Key menu (page
82) of the Controller menu.
Input Detection Sets the error detection of the input signal.
Detection Sets whether or not to detect the error of the input signal (Off or [On]).
Pixel Threshold Sets the pixel number of the gamut error in the frame to notify the gamut error detection.
When the pixel number of the error is over the set pixel number, the detection is notified.
Set to 00000 to 65535. [00000]
Signal Level Sets the upper and lower lines of every signal to detect the gamut error.
SDI YCbCr 10bit Upper Limit (upper limit)
Y: 0000 to 1023 [0983]
Cb: 0000 to 1023 [1004]
Cr: 0000 to 1023 [1004]
Lower Limit (lower limit)
Y: 0000 to 1023 [0020]
Pb: 0000 to 1023 [0019]
Pr: 0000 to 1023 [0019]
SDI RGB 10bit Upper Limit (upper limit)
G: 0000 to 1023 [0983]
B: 0000 to 1023 [0983]
R: 0000 to 1023 [0983]
Lower Limit (lower limit)
G: 0000 to 1023 [0020]
B: 0000 to 1023 [0020]
R: 0000 to 1023 [0020]
SDI YCbCr 12bit Upper Limit (upper limit)
Y: 0000 to 4095 [3935]
Cb: 0000 to 4095 [4019]
Cr: 0000 to 4095 [4019]
Lower Limit (lower limit)
Y: 0000 to 4095 [0080]
Cb: 0000 to 4095 [0077]
Cr: 0000 to 4095 [0077]
SDI RGB 12bit Upper Limit (upper limit)
G: 0000 to 4095 [3935]
B: 0000 to
4095 [3935]
R: 0000 to 4095 [3935]
Lower Limit (lower limit)
G: 0000 to 4095 [0080]
B: 0000 to 4095 [0080]
R: 0000 to 4095 [0080]
HDMI/DP YCbCr Upper Limit (upper limit)
Y: 0000 to 4095 [3935] (12bit conversion value)
Cb: 0000 to 4095 [4019] (12bit conversion value)
Cr: 0000 to 4095 [4019] (12bit conversion value)
Lower Limit (lower limit)
Y: 0000 to 4095 [0080] (12bit conversion value)
Cb: 0000 to 4095 [0077] (12bit conversion value)
Cr: 0000 to 4095 [0077] (12bit conversion value)
Menu Function and operation ([ ]: factory setting)