Sony Trinitron BVM-A14F5U - Structure of the SYSTEM CONFIGURATION Menu; Setting Lists in the SYSTEM CONFIGURATION Menu

40
[D] System Configuration – SYSTEM CONFIGURATION Menu
Chapter 2 Menu
Structure of the SYSTEM
CONFIGURATION Menu
Setting Lists in the SYSTEM
CONFIGURATION Menu
This section explains the setting lists displayed in the
menu.
How to read the settin lists
• For purposes of explanation, each setting list is preceded
by a menu number. These numbers are not displayed on
the screen.
For more information on the menu number, see “About
menu numbers” on page 23.
•The arrow mark (k) refers you to another setting list
that appears after you make the setting, or to an operation
that is to be carried out as a result of the setting.
[D] SYSTEM CONFIGURATION Menu
NETWORK...: Set the remote control function of the
network. k[D1]
PARALLEL REMOTE...: Set the parallel remote
control function. k[D2]
POWER…: Set the condition of the monitor when the
main power is turned on or the power is turned on
by remote operation. k[D3]
BLANKING SETTINGS...: Adjust the data for the
blanking. k[D4]
ON SCREEN SET...: Set the data for the screen
display. k[D5]
PASSWORD...: Set the passwords for the menu.
k[D6]
MAINTENANCE...: Display the menu for
maintenance. k[D7]
[D1] NETWORK... menu
MONITOR ID: Enter a monitor ID No..
Set to 01 to 99 (default setting is 01).
GROUP ID: Enter a group ID No..
Set to 01 to 99 (default setting is 01).
NETWORK SETTINGS...: Set the IP address,
subnet mask and default gateway. k[D11]
Level 1 Level 2 Level 3
NETWORK... [D1] MONITOR ID
GROUP ID
NETWORK
SETTINGS... [D11]
PARALLEL
REMOTE... [D2]
PARALLEL
REMOTE
1 PIN... - 8 PIN...
[D21]
PARALLEL
REMOTE [D211]
POWER... [D3] STANDBY MODE
POWER ON
STATUS
DEFAULT CH
DEGAUSS DELAY
BLANKING
SETTINGS... [D4]
ANCILLARY DATA
VITS BLK
ON SCREEN SET...
[D5]
FORMAT DISPLAY
POSITION
CH NO
POSITION
CH NAME
POSITION
PASSWORD... [D6] CHANGE
PASSWORD... [D61]
CHANGE
PASS WOR D [D611]
APPLY
PASSWORD... [D62]
APPLY PASSWORD
[D621]
MAINTENANCE... [D7]