Why is the LAMP/COVER indicator lit on my Sony Projector?
If the LAMP/COVER indicator lights up on your Sony Projector, it could mean one of two things: either the lamp has reached the end of its life and needs replacing, or the lamp has become too hot. If the lamp is too hot, wait 120 seconds for it to cool down before turning the power on again.
How to fix a Sony VPL-VW10HT Projector that will not turn on?
If your Sony Projector is not turning on, it could be due to several reasons: * If the power was recently turned off and on quickly, wait about 120 seconds before trying again. * Make sure the lamp cover is securely closed. * Also, ensure the air filter cover is properly closed.
What does 'Please replace the LAMP' mean on Sony Projector?
If your Sony Projector displays 'Please replace the LAMP,' it means it is time to replace the lamp. Please replace the lamp.
Why is there no picture on my Sony Projector?
If you're not getting any picture on your Sony Projector, consider these possibilities: * Check that all cables are properly connected. * Ensure the INPUT-A/B setting matches your input signal. * Verify that you've selected the correct input source using the INPUT key. * If the picture is cut off, press the MUTING PIC key. * If using a computer, ensure the output signals are set to output from an external monitor.
What does 'Please check INPUT-A setting' mean on Sony VPL-VW10HT Projector?
If your Sony Projector displays 'Please check INPUT-A setting,' it means you've input an RGB signal from the computer while INPUT-A in the SET SETTING menu is set to COMPONENT, DTV YPBPR, or DTV GBR. Set INPUT-A correctly.
What does 'Please check INPUT-B setting' mean on Sony VPL-VW10HT?
If your Sony Projector displays 'Please check INPUT-B setting,' it means you've input an RGB signal from the computer while INPUT-B in the SET SETTING menu is set to COMPONENT, DTV YPBPR, or DTV GBR. Set INPUT-B correctly.
Why does the on-screen display not appear on my Sony VPL-VW10HT?
If the on-screen display does not appear on your Sony Projector, it's possible that the STATUS in the SET SETTING menu has been set to OFF. To resolve this, set the STATUS in the SET SETTING menu to ON.
What to do if Sony VPL-VW10HT Projector says 'High temp.! Lamp off in 1 min'?
If the Sony Projector displays 'High temp.! Lamp off in 1 min,' it means the internal temperature is too high. Turn off the power and check the ventilation holes to ensure they are not blocked.
Why does my Sony VPL-VW10HT Projector Remote Commander not work?
If the Remote Commander (remote control) for your Sony Projector isn't working, consider these potential causes: * The batteries may be dead, so replace them with new ones. * If using a remote control cable, ensure it's properly connected to both the projector and the Remote Commander, or try disconnecting it. * Fluorescent lamps near the remote control detector can interfere, so adjust the SIRCS RECEIVER setting in the SET SETTING menu. * If using the Remote Commander wired, ensure batteries are installed.
Why is the TEMP/FAN indicator lit on my Sony VPL-VW10HT?
If the TEMP/FAN indicator is lit on your Sony Projector, it means the internal temperature is unusually high. Check to see if anything is blocking the ventilation holes.
To Next Page
General
