CL-16 GPIO Wiring Diagram Example
In this example, an external contact-closure switch starts recording and the GPIO outputs are used to sound a record bell and turn
off a lighting fan.
Record bell:
GPIO pin 1 settings:-
● Output
● Active Low
● Record
Record contact-closure switch:
GPIO pin 4 settings:
● Input
● Active Low
● Record
Lighting fan control (Fan requires +5 V on its trigger input to turn off):
GPIO pin 6 settings:
● Output
● Active High
● Record
CL-12
Selects the CL-12 menu. The CL-12 is a 12 channel linear fader controller with control over fader gain, PFL, Arm, EQ, buses,
outputs, coms, transport, metadata, and more. For detailed setup and operational information, please refer to the CL-12 User Guide.
Note that the CL-12 Linear Fader Controller cannot be used with another controller.
CL-12 menu settings:
1. L-X2 Level Controls: sets whether the L-X2 pots control bus level or output level or whether they are disabled altogether.
2. L-X2 Metering: sets whether the L-X2 meters display bus or output levels.
3. L-X2 Routing: sets whether L-X2 routing is to buses L-X2 or outputs L-X2.
4. LED Brightness: sets CL-12 LED brightness
5. SEL Follows PFL: selects whether a channel is automatically selected when its PFL is engaged.
To Next Page
Loading...
Need help?
General
