Page. 76 of 87
9600 baud
14400 baud
19200 baud
28800 baud
38400 baud
57600 baud
115200 baud
And then by pressing the OK button.
All the other framing and parity parameters can not be changed by the user because
they are set by the program initialization.
It should be noted that the Baud rate setting is needed to be set on the
KTerm_232.exe application’s side before a remote connection can be made. And it
may need to be changed due to a previous setting of a different baud rate.
The reason for this is because it is a permanent setting, which is stored into a private
data-base system, and will be recalled by the application whenever needed.
On the EXPERT 1.3K-FA side, the baud-rate is automatically synchronized by the data-
pattern being sent to it by KTerm_232.exe upon any query to the linear.
As mentioned above, the application usage is still the same as for the USB interface
version described earlier, but there are just some minor “look-and-feel” changes as
shown in the picture below:
The use of RS 232 port becomes a necessity when the device needs to be remoted via
the Internet. And since most specially designed devices, currently available on the
market, do not implement the USB port feature to being compliant to the USB front-end
of the EXPERT linear amplifiers.
To Next Page
Loading...
