SPECTRO SPECTROLAB - Initial start-up; Preparing the Instrument for First Use

Initial start-up
— 18 SPECTROLAB — 30.07.2015
5 Initial start-up
5.1 Preparing the instrument for use
Before switching on the instrument, proceed as follows:
1. Check if the mains voltage selector switch of the PC is set to the proper input
voltage (230V/115V).
2. Check the filling level of the gas-washing bottle. Fill with water if required, see
page 40.
3. Set the argon pressure to 5.0 bar (72 psi).
 If the argon pressure is not properly set, turbulences result in the spark
stand insert. Thus, correct measuring results cannot be obtained.
 The instrument is ready for use.