SPECTRO SPECTROLAB - Proceed with the Measurement

Operation
SPECTROLAB — 30.07.2015 — 25
6.4.2 Proceed with the measurement
To measure the probe, proceed as follows:
1. Start the required measuring program using function key F10.
2. Put the sample in position.
 The sample must fully cover the opening in the spark stand plate.
 The sample clamp must have contact with the sample (the safety circuit
is closed).
3. Use "Start" or the respective function key to start the measurement.
 The measurement is fully automated.
 The measurement is finished automatically.
 The measurement results are displayed on the screen.
4. Perform further measurements if required.
 Rotate the sample slightly for each further measurement. The respective
burn spots must not overlap.
5. Use "Finish" or press the respective function key to end the series of
measurement.
 The measurement is complete.