roller.
Note: Your aircraft manual may
refer to this as changing transmitter
flight control directions in the Control Test/Reverse Controls section.
Highlight the Speed value at the bottom of the screen and press the
roller to access. With the Speed value highlighted rotate the
roller to adjust the servo speed for the selected channel. Press the roller to accept the
value.
o Access the Reverse Function
With the transmitter on and the main or
telemetry screen up, press the
ervo Setu
Exponential
Affects the sensitivity around center but has no affect on the overall travel.
Positive Exponential reduces control sensitivity around neutral for more
precise control but does not affect the maximum control response. Note:
Positive and negative exponential values are available. A positive expo value
reduces control sensitivity around center. It does not affect maximum travel
and is recommended. Negative exponential values increase sensitivity around
neutral and is seldom used.
To Access the D/R and Expo Function
With the transmitter on and the main or telemetry screen displayed, press the roller. The
Function list will display.
Rotate the roller to highlight D/R and Expo then press to access. To Select a
Channel Highlight the channel then press the roller to access. Rotate the roller to
select the aileron, elevator or rudder channel. Press to accept.
roller to highlight Servo Setup then press to access the Servo Setup screens. Servo
travel will be highlighted. Rotate the roller until Speed appears in the channel position
then press to enter.
Dual Rates and exponentials are available on the aileron, elevator and rudder channels.
You can assign them to numerous switches including the flight mode switch. Dual Rate
Affects the overall travel which in turn affects
To Next Page
Loading...
Need help?
General
Weight and Dimensions
