Assigning a Programmable Mix to a Switch
Rotate the roller to highlight Sw: at the
bottom of the screen. Press the roller to
access the switch select function then
select the desired switch to turn on/off the
aileron to rudder mix. If you select On, the
mix will always be on.
Offset
The offset function establishes the point at
which the two mix rates converge. Typically
this rate is center or 0%. If an offset is
needed do the following: Programming an
Offset Rotate the roller to highlight Offset
then press the roller to highlight the Offset
rate. Rotate the roller to adjust the value.
Positive + and negative - values are
available shifting the offset in either
direction. Press the roller to accept the
offset value.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
