To add a servo output model start warning:
1. From Model Setup, touch Model Start Warnings.
2. Select the SERVO OUTPUT trigger type.
3. Touch the + icon to add a new warning. Touch the (
), if available, to remove a
current warning.
4. Select the desired output channel
from the first drop down button.
5. Select Over or Under from the next
drop down button to define which
side of the given output position the
warning will trigger.
6. Define the trigger point value. Values
from -100 to 100 may be entered.
7. Select the type of warning and enter
text-to-speech if Voice is selected.
To Next Page
Loading...
