ST STEVAL-STWINBX1 - Getting Started; Precautions for Use; Features; Kit Components

1 Getting started
1.1 Precautions for use
Warning: Charge your device with a DC 5 V–500 mA USB charger at a temperature from 10°C to
35°C.
The kit must be used within the working temperature range. It must never be exposed to
excessive heat such as direct sunlight, fire, or heating equipment.
Danger: Use only USB chargers equipped with short-circuit protections to prevent fire hazard.
Danger: Use only the LiPo battery provided with the kit (HiMax 752535). A replacement of the battery
with an incorrect type can defeat a safeguard.
LiPo batteries can be damaged and even explode if they are short-circuited or overcharge
or with an improper usage, such as mechanical crushes, hot oven, or battery cutting.
1.2 Features
• Multisensing wireless platform for vibration monitoring and ultrasound detection
•
Built around STWIN.box core system board with processing, sensing, connectivity, and expansion
capabilities
• Ultra-low power Arm
®
Cortex
®
-M33 with FPU and TrustZone at 160 MHz, 2048 kBytes Flash memory
(STM32U585AI)
• MicroSD card slot for standalone data logging applications
• On-board Bluetooth
®
low energy v5.0 wireless technology (BlueNRG-M2), Wi-Fi (EMW3080) and NFC
(ST25DV04K)
• Option to implement authentication and brand protection secure solution with STSAFE-A110
• Wide range of industrial IoT sensors:
– Ultra-wide bandwidth (up to 6 kHz), low-noise, 3-axis digital vibration sensor (IIS3DWB)
– 3D accelerometer + 3D gyro iNEMO inertial measurement unit (ISM330DHCX) with Machine
Learning Core
– High-performance ultra-low-power 3-axis accelerometer for industrial applications (IIS2DLPC)
– Ultra-low power 3-axis magnetometer (IIS2MDC)
– High-accuracy, high-resolution, low-power, 2-axis digital inclinometer with Embedded Machine
Learning Core (IIS2ICLX)
– Dual full-scale, 1.26 bar and 4 bar, absolute digital output barometer in full-mold package
(ILPS22QS)
– Low-voltage, ultra low-power, 0.5°C accuracy I²C/SMBus 3.0 temperature sensor (STTS22H)
– Industrial grade digital MEMS microphone (IMP34DT05)
– Analog MEMS microphone with frequency response up to 80 kHz (IMP23ABSU)
• Expandable via a 34-pin FPC connector
1.3 Kit components
The STEV
AL-STWINBX1 development kit includes:
• the STWIN core system (main board);
• a plastic case with M3 bolts;
• a 480 mAh 3.7 V LiPo battery;
• STEVAL-MKIGIBV4 ST-LINK adapter with programming cable;
• an adapter board for DIL24 sensors with a flexible cable.
UM2965
Getting started
UM2965 - Rev 1
page 2/58