3 How to program the board
3.1 How to program the STWIN.box in “USB mode”
This is the easiest mode if you just want to download a binary into the board, without the need of any debugging
capabilities.
The advantage is that no additional debugger is needed, just a USB T
ype C™ cable and
STM32CubeProgrammer installed on your PC.
To enter the "Firmware upgrade" mode, follow the procedure below.
Step 1. Unplug the STWIN.box board.
Step 2. Press the USR button.
Step 3. While keeping the button pressed, connect the USB Type C™ cable to the PC.
The board starts in the DFU mode and should be automatically recognized by the PC.
UM2965
How to program the board
UM2965 - Rev 1
page 28/58
To Next Page
Loading...
