February 2017 DocID027559 Rev 5 1/54
1
AN4661
Application note
Getting started with STM32F7 Series MCU hardware development
Introduction
This application note is intended for system designers who require an hardware
implementation overview of the development board, with a focus on the features:
• Power supply,
• Package selection,
• Clock management,
• Reset control,
• Boot mode settings,
• Debug management.
This document describes the minimum hardware resources required to develop an
application based on the STM32F7 Series devices.
Reference documents
The following documents are available on www.st.com:
•
Oscillator design guide for STM8S, STM8A and STM32 microcontrollers
application note (AN2867),
• STM32 microcontroller system memory boot mode application note (AN2606).
www.st.com
To Next Page
Need help?
General
