WATERPROOF FAST-LOCK REMOTE CONTROL USAGE
Front OPPOSITE
(Zone Key)
Front SAME
(Zone Key)
Rear SAME
(Zone Key)
Rear OPPOSITE
(Zone Key)
Fig. 1b
Remote Control Keys:
Several of the keys have dual functions. An underlined word on a key indicates that the key must
be held down until two beeps are heard for that function to operate. All keys with underlined
words operate with a delay time and will beep two times. The first beep occurs when the key is
initially pressed and the second beep occurs when the key actuation delay time expires.
MOV/STA:
│ START/STOP: The MOV/STA key toggles between moving and stationary modes. A speed or a [ ] in the patrol
window indicates moving mode, while a blank patrol window indicates stationary mode. With a
VSS cable installed, the radar will automatically switch between moving and stationary modes
based on the presence (or absence) of VSS pulses and [ ] will not be seen in the patrol window.
(See page 39 for more information on VSS.)
After selecting moving mode or stationary mode, the operator can use the four zone keys
(described below) to select the Target Zones to monitor targets on the front antenna and the rear
antenna simultaneously. The SAME and OPP icons display the zone selection in both moving
and stationary modes. Each antenna is totally independent of the other relative to Target Zone
selection. The stationary modes (and associated icons) for the front antenna are: stationary closing
(OPP), stationary away (SAME), and stationary bi-directional (OPP/SAME). The stationary
modes for the rear antenna are: stationary closing (SAME), stationary away (OPP), and stationary
bi-directional (OPP/SAME).
When in Stopwatch Mode, the START/STOP key is used to start and stop the electronic timing
of the target vehicle as it enters and exits the speed measurement zone.
The operator enters the stopwatch mode by turning Stopwatch Mode ON in the Operator Menu
(See Page 28). Press the MENU key and change the StO P setting from OFF to On followed by
pressing any of the four zone keys (OPP or SAME). The operator leaves Stopwatch Mode and
returns to radar mode by again pressing any of the four zone keys.
18
To Next Page
Loading...